RC-Lights REMOTE POWER SWITCH

#5090: REMOTE POWER SWITCH
Allows on/off function from the Rx & Tx. - wireless

To take full advantage of any extra 2-position control switch on the transmitter, plug an electronic remote power switch into the corresponding receiver channel to decode the position of the switch on the transmitter. Power to the lights is supplied via the RX and switched through the TX toggle switch.

DIP Switches - enable or disable these features
AUTO-OFF: All power to the output is switched off any time a bad signal is received, or the TX is turned off
REVERSIBLE: Changes which position of the TX stick is ON

Use the 3 wire power plug with a LED controller for constant power to Bank #1 and switched power to Bank #2.

Use the 2P connector housings to turn 3 wire power plug into standard 2 wire plug for standard +/- switching (LEDs are all in the same Bank).

Discard 3 wire power plug or save for future use if using with a RX Direct2LED™, or XTEC LED Lights.

INCLUDES
  Instruction Set
  (1) remote power switch
  (1) 3 wire power plug
  (2) 2P connector housings
  (2) zip ties & bases

Specification:
CURRENT DRAW (@6V): 1mA (10mA when output is switched on)
INPUT VOLTAGE: 4.8-6.0V
MAX OUTPUT CURRENT: 1.2A

Made in the USA