Home > XTEC RC LED Lights RC-Lights > XTEC Combo White Head and Red Tail Light System

XTEC Combo White Head and Red Tail Light System

XTEC Combo White Head and Red Tail Light System
Item# XTC0020
$34.80
Sale $27.84

XTEC Combo White Head and Red Tail Light System
XTC0020: White Head and Red Tail Light System
4.8-8.0vDC. Current limiting resistors are built right in.

Specially designed-proprietary electronics allows for direct-to-battery power supply. OR feel free to plug directly to your Rx with NO WORRIES about on-board battery drain.

Use the included "Y" harness, OR cut leads to desired length, and solder into one servo plug for the most compact/custom installation. With built in current limiting resistors, no bulky/expensive controller is needed.

24" lead with 2-pin Male Universal Plug (fits all Rx types)
1+ mile daylight visible / night-time incredible!

XTEC-exclusive Clear LUMILens and LUMIRing orchestrates the light to its optimal illumination.

INCLUDES
   (1) XTC0007W: Head Lights, White
   (1) XTC0018R: Tail Lights, Red
   (1) XTM0054: Universal "Y" Harness

Made in the USA

XTEC Combo White Head and Red Tail Light System

Accessories

RC-Lights ELECTRONIC BRAKE SWITCH
RC-Lights ELECTRONIC BRAKE SWITCH
#5092: ELECTRONIC BRAKE SWITCH
Turns Tail lights into BRAKE-LIGHTS.

Eliminate those mechanical switches, replace them with an electronic solution that keeps working run after run. Fully functional with any R/C vehicle - NITRO or ELECTRIC! Auto-Adjusting ON point to accommodate any trim adjustments. Reversible for a wide range of applications. Quick and easy installation.

Installs in-line with throttle servo or ESC. Plug Electronic Brake Switch into throttle channel on RX (receiver); plug throttle servo or ESC into brake switch.

Power from the RX is supplied to the LED controller through the electronic brake switch.

DIP Switches - enable or disable these features
CENTER-STICK: Changes if the brake lights are at normal or full intensity at center-stick
REVERSIBLE: Changes which direction of the throttle trigger is ON

Use the 3 wire power plug with a LED controller for constant power to Bank #1 and dual-intensity power to Bank #2.

Discard 3 wire power plug or save for future use if using with a RX Direct2LED™, OR XTEC LED Lights.

INCLUDES
  Instruction Set
  (1) electronic brake switch
  (1) 3 wire power plug
  (2) zip ties & bases

Specification:
CURRENT DRAW (@6V): 1mA (10mA when output is switched on)
INPUT VOLTAGE: 4.0-6.0V
MAX OUTPUT CURRENT: 1.2A

Made in the USA

RC-Lights ELECTRONIC BRAKE SWITCH
$14.99
Sale $11.99
RCL5092