RC-Lights 911STROBE™ 14 LED POLICE SYSTEM [5MM, 14"]

Due-in-stock 05/29

#5024 : 911STROBE™ 14 LED POLICE SYSTEM [5MM, 14"]
Powered directly from the RX / ALL MOUNTING HARDWARE INCLUDED

Use RCL5024 to install 4 white dual headlight strobes (fully adjustable), 4 blue and 4 red alternating roof strobe lights with single and double flash option, and 2 red dual-intensity electronic brake lights to any 1:12 to 1:8 size R/C car or truck. No extra channels, with included 911STROBE™ - 14 LED controller. This controller has headlight strobe, roof strobe, and EBS (electronic brake switch) functionality built right in with auxiliary (CH 3) channel input from a two-position switch on the TX.

Powered directly from the RX throttle & auxiliary channels using the included RX Pass-Thru™.

Auxiliary channel input can be used to switch power ON/OFF to the entire unit from a 2-position switch on the TX or it can be used to turn the "lights" ON/OFF so that headlights are constant and strobes are OFF until the switch is flipped then the headlights strobe and the roof strobes turn on.

LEDs are split into five banks: 4 constant/strobing headlights (2 each side R & L; headlight strobe rate fully-adjustable); 8 roof strobes (4 each side R & L; roof strobe rate fully-adjustable); and 2 switched dim or full bright depending on throttle stick position (GAS or BRAKE.)

To change headlight or tail light colors use 5mm LEDs.

Everything needed for a complete installation is included with every lighting system!


          shown with optional fog lights

Includes
  Instruction Set
  (1) #5055 911STROBE™ 14 LED controller
  (1) #5074 RX Pass-Thru™
  (1) 4P Power Plug
  (14) #5390-14 14" wire extensions
  (4) #5290-W 5mm white headlights & fogs
  (4) #5290-B 5mm blue strobe lights
  (6) #5290-R 5mm red brake & strobe lights
  (14) #5081 5mm chrome LED holders
  (14) #5082 standard 5mm LED holders
  (14) 2P connector housings
  (1) #5080 3.75"x3" aluminum tape
  (1) #5080 pre-cut aluminum tape
  (16) #5080 zip ties & bases

Specifications:
SYSTEM CURRENT DRAW (@6V): 80mA with brake lights dim, strobes ON; 100mA with brake lights engaged (A standard servo draws approx. 350mA) Run Time Loss Calculator

LED Controller
INPUT VOLTAGE: 3.6-7.4V [6V Optimal]
TYP OUTPUT CURRENT (per LED channel): 20-30mA
DIMENSIONS: 1.65" x 1.0" x 0.25"

Blue, Green, White, White Strobe, Red Strobe LEDs
FORWARD VOLTAGE: 3.2V
MAX CURRENT: 30mA

Amber, Red LEDs
FORWARD VOLTAGE: 1.9V
MAX CURRENT: 30mA

RC-Lights Quick Start Guide