RC-Lights Head, Turn & Electronic Brake Lights [5MM, 14"]

#5014: Head, Turn & Electronic Brake Lights [5MM, 14"]
Powered directly from the RX / ALL MOUNTING HARDWARE INCLUDED

Use RCL5014 to install 4 white dual headlights, 2 white fog lights, 4 amber adjustable rate turn signals, and 4 red dual-intensity electronic brake lights to any 1:12 to 1:8 size R/C car. No extra channels, with included TURNBRAKE™ - 14 LED controller . This controller has headlight strobe, turn signal, and EBS functionality built right in for a streamlined installation of a common setup for R/C cars & trucks.

Powered directly from the RX throttle & steering channels using the included RX Pass-Thru™.

Dual intensity brake light action is built right in! Throttle channel input fully reversible.

Fully-adjustable rate turn signals for Right and Left turn indication. Steering channel input fully reversible.

LEDs are split into seven banks: 2 constant fog; 4 constant/strobing headlights (2 each side R & L; headlight strobe rate fully-adjustable); 4 adjustable rate turn signals (2 each side R & L; front and back); and 4 switched dim or full bright depending on throttle stick position (GAS or BRAKE.)

Throttle and steering center-stick auto-detect for precise lighting effects every time.

To change headlight or tail light colors use 5mm LEDs.

Everything needed for a complete installation is included with every lighting system!



Includes
  Instruction Set
  (1) #5054 TURNBRAKE™ 14 LED controller
  (2) #5074 RX Pass-Thru™
  (1) 4P Power Plug
  (14) #5390-14 14" wire extensions
  (6) #5290-W 5mm white headlights & fogs
  (4) #5290-A 5mm amber turn signal lights
  (4) #5290-R 5mm red tail lights
  (14) #5081 5mm chrome LED holders
  (14) #5082 standard 5mm LED holders
  (14) 2P connector housings
  (1) #5080 3.75"x3" aluminum tape
  (1) #5080 pre-cut aluminum tape
  (16) #5080 zip ties & bases

NOTE: TURNBRAKE™ 14 LED Controller is not compatible with the Remote Power Switch (#5090).

Specifications:
SYSTEM CURRENT DRAW (@6V): 120mA with brake lights dim, turn signals off; 250mA with all LEDs fully bright (A standard servo draws approx. 350mA) Run Time Loss Calculator

LED Controller
INPUT VOLTAGE: 3.6-7.4V [6V Optimal]
TYP OUTPUT CURRENT (per LED channel): 20-30mA
DIMENSIONS: 1.65" x 1.0" x 0.25"

Blue, Green, White, White Strobe, Red Strobe LEDs
FORWARD VOLTAGE: 3.2V
MAX CURRENT: 30mA

Amber, Red LEDs
FORWARD VOLTAGE: 1.9V
MAX CURRENT: 30mA

RC-Lights Quick Start Guide